OrcaSlicer
OrcaSlicer 3d printer software. By shawn.webb.framework16-01.
more
Announcing is a node declaring it will serve the repository; what is on that node's disk cannot be verified from here. The median repository is seeded by 6 nodes.
Seed count over time
The seed count has swung between 2 and 13 over 90 days of recorded history (12 August to 9 November 2026), and stands at 9, near the 6 it opened at. The largest single change was +7 on 5 September 2026, across 29 recorded moves. The line moves only on a clear change; small ones do not show.
Steady at a typical 6 seeds
same as the week ending 2 November 2026
7 → 6 typical seeds
too small to count as a move · against the week ending 10 October 2026
About this repository
- Repository ID
rad:zMwo6xQDsc8vaMezvkBWkTyWPD3o- Delegates
- shawn.webb.framework16-01
did:key:z6Mkp9s3W8zN2qigmUirtvJ8NesXXZkYsYC6XEjdGcSXFeeR - First seen by radicle.at
- 7 July 2026 or earlier
- Last seen
- 9 November 2026
- Classification
- Community. Published by a peer on the Radicle network. This site's own label; the repository does not declare it.
More by shawn.webb.framework16-01
| Repository | Seeds | 7d |
|---|---|---|
| HardenedBSD-src | 32 | 0 |
| HardenedBSD-ports | 28 | 0 |
| hbsdmon | 20 | 0 |
| hbsd-rad-helpers | 18 | 0 |
| HardenedBSD-builder | 17 | 0 |
shawn.webb.framework16-01 maintains 40 repositories here, including this one. See all of them · Chart these together
Seed it too
Run this in a terminal on a machine with a Radicle node (radicle.dev to install one):
rad seed rad:zMwo6xQDsc8vaMezvkBWkTyWPD3o
Seeding replicates the repo and counts your node toward the seed count above, which can take a while to show. Tap the command to copy it.
To seed every public repository at once, run a permissive seed node, one that takes whatever the network offers. The Radicle seeder guide covers setup, and radicle-seed-prune frees disk as it fills, so there is no minimum disk to start with.